D-Link DGS-1510 Series - Page 369

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
366
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the lldp notification enable command to enable the sending of LLDP notifications.
Use the lldp med notification enable command to enable the sending of LLDP-MED notifications.
Example
This example shows how to enable the sending of LLDP MED notifications for eth2/0/1.
Switch# configure terminal
Switch(config)# interface eth2/0/1
Switch(config-if)# lldp med notification enable
Switch(config-if)#
43-19 lldp subtype
This command is used to configure the subtype of LLDP TLV(s).
lldp subtype port-id {mac-address | local}
Parameters
port-id
Specifies the subtype of the port ID TLV.
mac-address
Specifies the subtype of the port ID TLV to “MAC Address (3)” and
the field of “port ID” will be encoded with the MAC address.
local
Specifies the subtype of the port ID TLV to use “Locally assigned
(7)” and the field of “port ID” will be encoded with the port number.
Default
The subtype of port ID TLV is local (port number).
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to specify the subtype of LLDP TLV(s). A port ID subtype is used to indicate how
the port is being referenced in the port ID field.
Example
This example shows how to configure the subtype of the port ID TLV to mac-address.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp subtype port-id mac-address
Switch(config-if)#
43-20 show lldp
This command is used to display the Switch’s general LLDP configuration.