D-Link DGS-1510 Series - Page 370

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
367
show lldp
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the LLDP system’s global configurations.
Example
This example shows how to display the LLDP system’s global configuration status.
Switch#show lldp
LLDP System Information
Chassis ID Subtype : MAC Address
Chassis ID : 3C-1E-04-A1-CC-00
System Name : Switch
System Description : Gigabit Ethernet SmartPro Switch
System Capabilities Supported: Repeater, Bridge
System Capabilities Enabled : Repeater, Bridge
LLDP-MED System Information:
Device Class : Network Connectivity Device
Hardware Revision : A1
Firmware Revision : 1.00.012
Software Revision : 1.30.003
Serial Number :
Manufacturer Name : D-Link Corporation
Model Name : DGS-1510-28XMP Gigabit Ethernet
Asset ID :
PoE Device Type : PSE Device
PoE PSE Power Source : Primary
LLDP Configurations
LLDP State : Disabled
LLDP Forward State : Disabled
Message TX Interval : 30
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
43-21 show lldp interface
This command is used to display the LLDP configuration at the physical interface.
show lldp interface INTERFACE-ID [, | -]