D-Link DGS-1510 Series - Page 443

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
440
no ntp request-key
Parameters
KEY-ID
Specifies the NTP key ID. The value is from 1 to 255.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The ntpdc utility program uses a proprietary protocol specific to the implementation of NTP.
Example
This example shows how to define the NTP request key.
Switch#configure terminal
Switch(config)#ntp request-key 45
Switch(config)#
51-10 ntp server
This command is used to enable the Switch to synchronize the time with an NTP server. Use the no
form of this command to disable this feature.
ntp server {IP-ADDRESS | IPv6-ADDRESS} [version NUMBER] [key KEY-ID] [prefer] [min-poll
INTERVAL] [max-poll INTERVAL]
no ntp server {IP-ADDRESS | IPv6-ADDRESS}
Parameters
IP-ADDRESS
Specifies the IPv4 address of the NTP server.
IPv6-ADDRESS
Specifies the IPv6 address of the NTP server.
version
(Optional) Specifies the NTP version number.
NUMBER
(Optional) Specifies to enter the NTP version number from 1 to 4.
The default version number is 4.
key
(Optional) Specifies the authentication key.
KEY-ID
(Optional) Specifies the authentication key ID from 1 to 255.
prefer
(Optional) Specifies to be the preferred peer for synchronization.
min-poll
(Optional) Specifies the minimum poll interval fro NTP messages.
This value is calculated as 2 to the power of the minimum poll
interval value specified. For example, if the value specified here is
6, the minimum poll interval that will be used is 64 seconds (2
6
=64).
INTERVAL
(Optional) Specifies to enter the minimum poll interval value. The
default value is 6.
max-poll
(Optional) Specifies the maximum poll interval fro NTP messages.
This value is calculated as 2 to the power of the maximum poll