D-Link DGS-1510 Series - Page 444

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
441
interval value specified. For example, if the value specified here is
6, the maximum poll interval that will be used is 64 seconds (2
6
=64).
INTERVAL
(Optional) Specifies to enter the maximum poll interval value. The
default value is 10.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable the Switch to synchronize the time with an NTP server. Use the no
form of this command to disable this feature.
Example
This example shows how to configure the IP address of the NTP server to 192.168.10.33 using NTP
version 2.
Switch#configure terminal
Switch(config)#ntp server 192.168.10.33 version 2
Switch(config)#
51-11 ntp trusted-key
This command is used to specify the trusted key for a peer NTP system to authenticate. Use the no
form of this command to disable this feature.
ntp trusted-key KEY-ID
no ntp trusted-key KEY-ID
Parameters
KEY-ID
Specifies the NTP key ID. The value is from 1 to 255.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to specify the trusted key for a peer NTP system to authenticate. Use the no
form of this command to disable this feature.
Example
This example shows how to configure the NTP trusted key.