DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
442
Switch#configure terminal
Switch(config)#ntp trusted-key 45
Switch(config)#
51-12 ntp update-calendar
This command is used to periodically update the hardware clock from an NTP source. Use the no
form of this command to disable this feature.
ntp update-calendar
no ntp update-calendar
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to periodically update the hardware clock from an NTP source. Use the no
form of this command to disable this feature.
Example
This example shows how to periodically update the hardware clock from an NTP source.
Switch#configure terminal
Switch(config)#ntp update-calendar
Switch(config)#
51-13 service ntp
This command is used to enable NTP. Use the no form of this command to disable this feature.
service ntp
no service ntp
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
To Next Page
Loading...
