D-Link DGS-1510 Series - Page 446

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
443
Level: 12.
Usage Guideline
This command is used to enable NTP. Use the no form of this command to disable this feature.
Example
This example shows how to enable NTP.
Switch#configure terminal
Switch(config)#service ntp
Switch(config)#
51-14 show ntp associations
This command is used to display the status of NTP associations.
show ntp associations [detail]
Parameters
detail
(Optional) Specifies to display detail information about each NTP
association.
Default
Not applicable.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the status of NTP associations.
Example
This example shows how to display the NTP associations.
Switch#show ntp associations
Remote Local St Poll Reach Delay Offset Disp
=======================================================================
=192.168.10.33 0.0.0.0 16 128 0 0.00000 0.000000 3.99217
+192.168.22.33 0.0.0.0 16 128 0 0.00000 0.000000 3.99217
+ Symmetric active, - Symmetric passive, = Client, * System Peer
Switch#
Display Parameters
Leading Characters
The first characters in a display line can be one of the following
characters:
+: Symmetric active mode.
-: Symmetric passive mode.
=: Client mode.