D-Link DGS-1510 Series - Page 544

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
541
This example shows how to configure the trust-point “TP1” as the primary trust-point.
Switch# configure terminal
Switch(config)# crypto pki trustpoint TP1
Switch(ca-trustpoint)# primary
Switch(ca-trustpoint)#
61-6 show crypto pki trustpoints
This command is used to display the trust-points that are configured in the Switch.
show crypto pki trustpoints [TRUSTPOINT]
Parameters
TRUSTPOINT
(Optional) Specifies the name of the trust-point to be displayed.
Default
None.
Command Mode
Privileged EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If no parameter is specified, all trust-points will be displayed.
Example
This example shows how to display all trust-points.
Switch# show crypto pki trustpoints
Trustpoint Name : TP1 (primary)
Imported certificates:
CA : tongken.ca
local certificate : webserver.crt
local private key : webserver.prv
Trustpoint Name : TP2
Imported certificates:
CA : chunagtel.ca
local certificate : openflow.crt
local private key : openflow.prv
Switch#
61-7 show ssl-service-policy
This command is used to display the SSL service policy.
show ssl-service-policy [POLICY-NAME]