DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
546
The sampling rate in operation may be automatically adjusted to a lower rate when the system is
overloading.
Example
This example shows how to create the sampler of instance 1 with the receiver as 1, inbound, rate as
1024 and size as 128 bytes.
Switch# configure terminal
Switch(config)# interface ethernet 1
Switch(config-if)# sflow sampler 1 receiver 1 inbound sampling-rate 1024 max-
header-size 128
Switch(config-if)#
62-3 sflow poller
This command is used to create or configure a poller for the sFlow agent. Use the no form of this
command to delete a poller.
sflow poller INSTANCE [receiver RECEIVER] [interval SECONDS]
no sflow poller INSTANCE
Parameters
Specifies the instance index if multiple pollers are associated with
one interface. The range is from 1 to 65535.
(Optional) Specifies the receiver’s index for this poller. If not
specified, the value is 0. The user cannot configure the value to 0.
(Optional) Specifies the maximum number of seconds between
successive polling samples. The range is from 0 to 120. 0 means
disable. If not specified, the default is 0.
Default
By default, no poller is created.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command without keywords to create a default poller or to reset an existing poller to default
values. Use the no form of this command with an instance to delete one poller.
The user can only specify a receiver that has its owner name setup. If the receiver associated with the
poller has its owner name is reset, the poller will be reset to the default setting.
Setting the polling interval to 0 disables the polling. An interface can be configured with multiple
pollers.
Example
This example shows how to create the poller of instance 1 with receiver as 1 and interval as 20
seconds.
To Next Page
Loading...
Need help?
General
