D-Link DGS-1510 Series - Page 550

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
547
Switch# configure terminal
Switch(config)# interface ethernet 1
Switch(config-if)# sflow poller 1 receiver 1 interval 20
Switch(config-if)#
62-4 show sflow
This command is used to display sFlow information.
show sflow [agent | receiver | sampler | poller]
Parameters
agent
(Optional) Specifies to display sFlow agent information.
receiver
(Optional) Specifies to display information of all receivers.
sampler
(Optional) Specifies to display information of all samplers.
poller
(Optional) Specifies to display information of all pollers.
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display sFlow information.
Example
This example shows how to display all types of sFlow objects’ information.