DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
573
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the SIM interval in seconds for single IP management protocol
sending messages.
Example
This example shows how to configure the interval for the single IP management protocol.
Switch# configure terminal
Switch(config)# sim interval 60
Switch(config)#
64-6 sim management vlan
This command is used to configure SIM management VLAN. Use the no form of this command to
revert to the default setting.
sim management vlan VLAN-ID
no sim management vlan
Parameters
Default
By default, this option is set the VLAN 1.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The single IP management group commander and member will send and receive the SIM message
on the SIM management VLAN.
Example
This example shows how to configure the single IP management VLAN to 100.
Switch# configure terminal
Switch(config)# sim management vlan 100
Switch(config)#
64-7 sim remote-config
This command is used to remotely login and configure the single IP management group member or
exit from the remote configuration.
sim remote-config {member MEMBER-ID | exit}
To Next Page
Loading...
