DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
574
Parameters
Specifies the member that login.
Specifies to exit from the current configuring member.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
The SIM Commander switch can login to its group members and configure them by the member ID.
This command only can be used on the Commander switch.
Example
This example shows how to login the single IP management group member device.
Switch# sim remote-config member 1
Switch#
64-8 copy sim
This command is used to copy a file to single IP management group members.
copy sim SOURCE-URL DESTINATION-URL [member MEMBER-LIST]
Parameters
Specifies the source URL to be uploaded to the server. The source
URL is located on the member switch. When the running
configuration is specified as the source URL, the purpose is to
upload the running configuration to the TFTP server. When the
system log is specified as source URL, the system log can be
retrieved to the TFTP server.
Specifies the destination URL for the file download. The destination
URL is located on the member switch. When the running
configuration is specified as the destination URL, the purpose is to
download the running configuration from the TFTP server to
member switches. When the firmware is specified as the destination
URL, the purpose is to download the firmware from the TFTP server
to member switches. The boot image on the member switches will
be replaced by the downloaded file.
(Optional) Specifies the member switch to download the file.
Multiple members can be specified at a time. Use ‘,’ to separate
multiple IDs, or “-“ to denote a range of interface IDs.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
To Next Page
Loading...
