D-Link DGS-1510 Series - Page 603

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
600
show storm-control interface INTERFACE-ID [, | -] [broadcast | multicast | unicast]
Parameters
INTERFACE-ID
Specifies the port’s interface ID.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
broadcast
Specifies to display the current broadcast storm setting.
multicast
Specifies to display the current multicast storm setting.
unicast
Specifies to display the current unicast (DLF) storm setting.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If the interface ID is not specified, all interfaces configurations will be displayed.
If the packet type is not specified, all types of storm control settings will be displayed.
Example
This example shows how to display the current broadcast storm control settings.
Switch# show storm-control interface range ethernet 3/0/1-3/0/6 broadcast
Polling Interval : 15 sec Shutdown Retries : Infinite
Interface Action Threshold Current State
-----------------------------------------------------------
eth3/0/1 Drop 500/300 pps 200 pps Forwarding
eth3/0/2 Drop 80/64 % 20 % Forwarding
eth3/0/3 Drop 80/64 % 70 % Dropped
eth3/0/4 Shutdown 60/50 % 20 % Forwarding
eth3/0/5 None 60000/50000 kbps 2000 kbps Forwarding
eth3/0/6 None - - Inactive
Total Entries: 6
Switch#
This example shows how to display all interface settings for the range from port 3/0/1 to port 3/0/2.