DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
601
Switch# show storm-control interface eth3/0/1-2
Polling Interval : 15 sec Shutdown Retries : Infinite
Trap : Disabled
Interface Storm Action Threshold Current State
---------------------- --------------------------------------------
eth3/0/1 Broadcast Drop 80/64 % 50% Forwarding
eth3/0/1 Multicast Drop 80/64 % 50% Forwarding
eth3/0/1 Unicast Drop 80/64 % 50% Forwarding
eth3/0/2 Broadcast Shutdown 500/300 pps - Error Disabled
eth3/0/2 Multicast Shutdown 500/300 pps - Error Disabled
eth3/0/2 Unicast Shutdown 500/300 pps - Error Disabled
Total Entries: 6
Switch#
Display Parameters
The configured action, the possible actions are: Drop, Shutdown,
None.
The configured threshold.
The actual traffic rate which is currently flowing though the interface.
Its unit may be percentage, kbps, PPS based on the configured
meter mode. Because hardware can only counts by PPS, this value
of this filed may be a rough value for percentage and kbps.
The current state of storm control on a given interface for a given
traffic type. The possible states are:
Forwarding: No storm event has been detected.
Dropped: A storm event has occurred and the storm traffic
exceeding the threshold is dropped.
Error Disabled: The port is disabled due to a storm.
Link Down: The port is physically linked down.
Inactive: Indicates that storm control is not enabled for the given
traffic type.
To Next Page
Loading...
