D-Link DGS-1510 Series - Page 625

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
622
This example shows how to display the content of the running configuration file.
Switch#show running-config
Building configuration...
Current configuration : 37933 bytes
#-------------------------------------------------------------------------------
# DGS-1510-28XMP Gigabit Ethernet SmartPro Switch
# Configuration
#
# Firmware: Build 1.30.003
# Copyright(C) 2015 D-Link Corporation. All rights reserved.
#-------------------------------------------------------------------------------
# STACK
end
end
# DEVICE
configure terminal
end
# AAA
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
70-10 show startup-config
This command is used to display the content of the startup configuration file.
show startup-config
Parameters
None.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
This command displays the configuration settings that the system will be initialized with.
Example
This example shows how to display the content of the startup configuration file.