D-Link DGS-1510 Series - Page 630

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
627
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
An existing discriminator can be configured. The later setting will overwrite the previous setting.
Associate a discriminator with the logging buffered and the logging server command.
Example
This example shows how to create a discriminator named “buffer-filter” which specifies two sub-filters,
one based on the severity level and the other based on the facility.
Switch# configure terminal
Switch(config)# logging discriminator buffer-filter facility includes STP severity
includes 1-4,6
Switch(config)#
71-5 logging server
This command is used to create a SYSLOG server host to log the system messages or debug output.
Use the no form of this command to remove a SYSLOG server host.
logging server {IP-ADDRESS | IPV6-ADDRESS} [severity {SEVERITY-LEVEL | SEVERITY-
NAME}] [facility FACILITY-TYPE] [discriminator NAME] [port UDP-PORT]
no logging server {IP-ADDRESS | IPV6-ADDRESS}
Parameters
IP-ADDRESS
Specifies the IP address of the SYSLOG server host.
IPV6-ADDRESS
Specifies the IPv6 address of the log server host.
SEVERITY-LEVEL
(Optional) Specifies the severity level of system messages. The
messages at that severity level or a more severe level will be
logged to the log server. This value must be between 0 and 7. 0 is
the most severe level. If not specified, the default severity level is
warnings (4).
SEVERITY-NAME
(Optional) Specifies the severity level of system messages by one
of the following names: emergencies, alerts, critical, errors,
warnings, notifications, informational, debugging.
FACILITY-TYPE
(Optional) Specifies the facility type as a decimal value from 0 to 23.
If not specified, the default facility is local7 (23).
discriminator
(Optional) Specifies to filter the message to the log server based on
discriminator.
port UDP-PORT
(Optional) Specifies the UDP port number to be used for the
SYSLOG server. Valid values are 514 (the IANA well-known port) or
any value from 1024 to 65535. If not specified, the default UDP port
is 514.
Default
None.
Command Mode