D-Link DGS-1510 Series - Page 691

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
688
unitID: Box ID.
Macaddr: MAC address.
Event description: Hot removal.
Log Message: Unit: <unitID>, MAC: <macaddr> Hot removal.
Parameters description:
unitID: Box ID.
Macaddr: MAC address.
Informational
Event description: Stacking topology change.
Log Message: Stacking topology is <Stack_TP_TYPE>. Master(Unit <unitID>,
MAC:<macaddr>).
Parameters description:
Stack_TP_TYPE: The stacking topology type is one of the following:
1. Ring,
2. Chain.
unitID: Box ID.
Macaddr: MAC address.
Informational
Event description: Backup master changed to master.
Log Message: Backup master changed to master. Master (Unit: <unitID>).
Parameters description:
unitID: Box ID.
Informational
Event description: Slave changed to master
Log Message: Slave changed to master. Master (Unit: <unitID>).
Parameters description:
unitID: Box ID.
Informational
Event description: Box ID conflict.
Log Message: Hot insert failed, box ID conflict: Unit <unitID> conflict (MAC:
<macaddr> and MAC: <macaddr>).
Parameters description:
unitID: Box ID.
macaddr: The MAC addresses of the conflicting boxes.
Critical
Storm Control
Log Description
Severity
Event description: Storm occurrence.
Log Message: <Broadcast | Multicast | Unicast> storm is occurring on
<interface-id>.
Parameters description:
Broadcast: Storm is resulted by broadcast packets(DA =
FF:FF:FF:FF:FF:FF).
Multicast: Storm is resulted by multicast packets, including unknown L2
multicast, known L2 multicast, unknown IP multicast and known IP
multicast.
Unicast: Storm is resulted by unicast packets, including both known and
unknown unicast packets
interface-id: The interface ID on which a storm is occurring.
Warning
Event description: Storm cleared.
Log Message: <Broadcast | Multicast | Unicast> storm is cleared on <interface-
id>.
Parameters description:
Broadcast: Broadcast storm is cleared.
Informational