D-Link DNS-313 User Manual

5D-Link DNS-313 User Manual
Section 1 - Product Overview
Rear Panel (Connections)
Power
Receptacle
Direct Attached/
Network Storage
Mode Switch.
D r i v e E j e c t
Lever
Reset Button
COMPONENT DESCRIPTION
Cooling Fan The cooling fan is used to cool the hard
drive. The cooling fan will run during
system bootup and will turn off after bootup
has completed. The DNS-313 will also
turn on the fan if the system temperature
becomes too high and turn off the fan when
the system temperature lowers down to a
reasonable level.
Do not block this opening.
Reset Button Use this to reset the DNS-313 to factory
default settings. To reset, insert a ballpoint
pen and hold the recessed button down for
a few seconds.
Direct Attached/
Network
Storage Mode
Switch
Slide the switch to select whether the
DNS-313 will be used as a USB 2.0
portable drive or as a Network Storage
device. See the “Direct Attached/Network
Storage Mode” section on page 6 for more
information on how the USB/Ethernet port
switch works.
Drive Eject
Lever
Use the provided lever to eject the hard
drive. The front panel must be removed
before ejecting the drive.
Power
Receptacle
The 12V/ 3A power supply connects here.
Cooling Fan.

D-Link DNS-313 Specifications

Device Interfaces

Gigabit Ethernet port	1 10/100/1000
USB port	1 USB 2.0
Power socket	external power adapter

Operating Environment

Operating temperature	0˚ to 55˚ C (32˚ to 131˚ F)
Storage temperature	-20˚ to 70˚ C (-4˚ to 158˚ F)
Operating humidity	5% to 90% (non-condensing)

Weight and Dimensions

Dimensions	200 (L) x 124 (H) x 49 (W) mm
Weight	1.29 Kg
Supported hard drive type	3.5-inch internal SATA