18D-Link DNS-313 User Manual
Section 3 - Configuration
Click n’ Connect Utility
Modify Existing DNS-313 Settings
If selecting the Modify existing DNS-313 settings Click n’ Connect menu option, carry out the following steps:
1. The Click n’ Connect utility displays all of the D-Link
DNS NAS devices that have been discovered on
your network.
Select the DNS-313 that you want to modify
from the list and click the Next button to proceed
to the next screen.
Note: If you have more than one DNS-313
on your network, make a note of the device’s
MAC address that is located on a sticker on
the base of the device and click the DNS-313
with the corresponding MAC address.
2. The Click n’ Connect utility allows you to modify
the drive letter that the DNS-313 is mapped to on
your computer and the device name.
To change the drive letter that the DNS-313 is
mapped to, select a new Drive Letter from the
Drive Letter pull-down menu.
To change the name that various network services
use to identify the device, type a new Name in the
Device Name eld.
To Next Page
Loading...
