D-Link DWC-2000

62
configured servers.
4.11 system remote_management https configure
S.No
Command Name
Description
Type and Description
1
save
Save access Management
changes for https.
2
exit
Save access Management
changes for https and exit
current mode.
3
cancel
Roll back Remote Mgmt
changes.
4
enable
Enable/disable remote mgmt
over https.
Boolean choice
5
type
Enable/disable remote mgmt
over https.
Unsigned integer
6
from_address
Set the starting IP in case of
range, and the IP to be allowed
access in case of granting
access to a particular machine
IP address
AAA.BBB.CCC.DDD where
each part is in the range 0-
255
7
end_address
Set the Ending IP in case of
range.
IP address
AAA.BBB.CCC.DDD where
each part is in the range 0-
255
8
port
Set the port you want to use for
HTTP.
Unsigned integer
9
enable_remote_snmp
Enable/disable remote snmp.
Boolean choice
4.12 system remote_management telnet configure
S.No
Command
Name
Description
Type and Description
1
save
Save access Management
changes for telnet.
2
exit
Save access Management
changes for telnet and exit
current mode.
3
cancel
Roll back changes to Remote
Mgmt.
4
enable
Enable/disable Remote mgmt
over telnet.
Boolean choice
5
type
The kind of access you want to
allow.
Unsigned integer
6
from_address
Set the starting IP range, and