D-Link DWC-2000 - Net Radvd Configure

97
Description
1
<portName>
Port management configuration mode.
Port name.
2
save
Saves port management configuration
changes.
3
exit
Saves port management configuration
changes and exits current mode.
4
cancel
Rolls back port management configuration
changes.
5
enable
Enables/Disables the port status.
Boolean
choice.
6
auto_negotiation_enable
Allows the gateway and network to
determine the optimal port settings.
Boolean
choice
7
duplex_mode
Choose between Half Duplex and Full
Duplex based on the port support. The
default is Full Duplex for all ports.
select the
duplex mode
8
speed
One of three port speeds can be selected:
10 Mbps, 100 Mbps and 1000 Mbps (i.e. 1
Gbps). The default setting is 1000 Mbps
for all ports.
select the
speed
7.18 net radvd configure
S.No
Command Name
Description
Type and
Description
1
save
Saves radvd configuration changes.
2
exit
Saves radvd configuration changes and exits
current mode.
3
cancel
Rolls back radvd configuration changes.
4
enable
Enables the radvd process to allow stateless
auto configuration of the IPv6 LAN network.
Boolean choice
5
mode
Selects N to send router advertisements
(RA’s) to all interfaces else Y
radvd
advertisement
mode type.
6
interval
The time in seconds between sending
unsolicited multicast RA’s. The default is 30
seconds.
PPPOE idle
timeout Type.
7
flags
RA Flags.
8
flags
managed_enable
Enable to use the administered/stateful
protocol for address auto configuration.
Boolean choice.
9
flags
other_enable
When the other flag is selected the host uses
administered/stateful protocol of other (i.e.
Boolean choice.