D-Link DWL-2100AP User Manual

19DWL-2100AP User Manual
Enable or Disable SSID broadcast. Enabling this feature broadcasts the
SSID across the network.
6 is the default channel for IEEE 802.11g. All devices on the network must
share the same channel.
Note: The wireless adapters will automatically scan and match the wireless
setting.
This option is unavailable in WDS with AP mode.
Enter the MAC addresses of the APs in your network that will serve as
bridges to wirelessly connect multiple networks.
Select Open System to communicate the key across the network.
Select Shared Key to limit communication to only those devices that share
the same WEP settings.
Select Open System/Shared Key to allow either form of data encryption.
Select WPA-PSK, WPA2-PSK, or WPA-Auto-PSK to secure your
network using a password and dynamic key changes (No RADIUS server
required).
SSID Broadcast:
Channel:
Auto Channel
Scan:
Remote AP MAC
Address:
Authentication:
Note: WDS is not completely specified in WiFi or IEEE standards. Communication with other vendor´s
access points is not guaranteed.

D-Link DWL-2100AP Specifications

General

Frequency Band	2.4 GHz
Data Transfer Rate	54 Mbps
Security	WEP, WPA, WPA2
LAN Port	1 x 10/100Base-TX (RJ-45)
Device Type	Wireless Access Point
Form Factor	External
Data Link Protocol	IEEE 802.11b, IEEE 802.11g
Antenna Qty	1
Interface	1 x 10Base-T/100Base-TX - RJ-45
Power Supply	External power adapter
Wireless Standard	IEEE 802.11b/g
Antenna	Detachable
Compliant Standards	IEEE 802.11b, IEEE 802.11g
Encryption Algorithm	WEP, WPA, WPA2
Authentication Method	RADIUS
Features	MAC address filtering
Operating Modes	Access Point, Repeater