D-Link DWL-2100AP User Manual

55DWL-2100AP User Manual
When selecting multiple devices for configuration, some options are
unavailable for configuration by default as noted(*) below:
This allows you to change the device name for the selected
access point. You must place a checkmark in the Device Name
box to change the name. This option should only be configured
when one access point is selected for configuration.
If you’ve selected one device for configuration and you want
to change the IP address of the device, check the IP Address
box. You ca then enter an IP address and Subnet Mask for the
selected access point. This option should only be configurable
when one access point is selected for configuration. To configure
multiple devices with an IP address at one time, please reference
the previous page.
Enter the IP address of your gateway, typically your router
address.
General
Device Name(*):
IP address and
Subnet Mask(*):
Gateway:

D-Link DWL-2100AP Specifications

General

Frequency Band	2.4 GHz
Data Transfer Rate	54 Mbps
Security	WEP, WPA, WPA2
LAN Port	1 x 10/100Base-TX (RJ-45)
Device Type	Wireless Access Point
Form Factor	External
Data Link Protocol	IEEE 802.11b, IEEE 802.11g
Antenna Qty	1
Interface	1 x 10Base-T/100Base-TX - RJ-45
Power Supply	External power adapter
Wireless Standard	IEEE 802.11b/g
Antenna	Detachable
Compliant Standards	IEEE 802.11b, IEEE 802.11g
Encryption Algorithm	WEP, WPA, WPA2
Authentication Method	RADIUS
Features	MAC address filtering
Operating Modes	Access Point, Repeater