D-Link DWL-2100AP User Manual

56DWL-2100AP User Manual
DHCP Client:
There is a pulldown menu to select enabled or disabled. When enabled, the
selected device(s) will function as a DHCP client(s). This allows them to receive
IP configuration information from a DHCP server. When disabled, the access
point(s) must have a static IP address assigned to them.
This pulldown selection defines the timeout period during a Telnet session with
the selected device(s).
This pulldown selection enables or disables the ability to Telnet into the selected
device(s).
Check the box to limit the administrator to login to the DWL-2100AP from a
certain IP address.
Check Enabled to use SNMP. SNMP is disabled by default.
When SNMP is enabled, you may modify the public community string
(read-only).
When SNMP is enabled, you may modify the private community string
(read-write).
Console Protocol:
Telnet Timeout:
Limit Administrator IP:
SNMP Status:
Public Community String:
Private Community String:

D-Link DWL-2100AP Specifications

General

Frequency Band	2.4 GHz
Data Transfer Rate	54 Mbps
Security	WEP, WPA, WPA2
LAN Port	1 x 10/100Base-TX (RJ-45)
Device Type	Wireless Access Point
Form Factor	External
Data Link Protocol	IEEE 802.11b, IEEE 802.11g
Antenna Qty	1
Interface	1 x 10Base-T/100Base-TX - RJ-45
Power Supply	External power adapter
Wireless Standard	IEEE 802.11b/g
Antenna	Detachable
Compliant Standards	IEEE 802.11b, IEEE 802.11g
Encryption Algorithm	WEP, WPA, WPA2
Authentication Method	RADIUS
Features	MAC address filtering
Operating Modes	Access Point, Repeater