9DWL-2100AP User Manual
It’s best to use a computer (with an Ethernet adapter) that is connected to a switch or router for configuring the
DWL-2100AP. The default IP address for the DWL-2100AP is 192.168.0.50 with a Subnet Mask of
255.255.255.0.
You will need to assign your computer a Static IP address within the same range as the DWL-2100AP’s
IP address for the purpose of configuring the DWL-2100AP. See the Appendix if you need assistance in
assigning a Static IP address for your network adapter.
Before You Begin
A. First, connect the power adapter to the receptor at the back panel of the
DWL-2100AP and then plug
the other end of the power adapter to a wall outlet or power strip. The Power LED will turn ON to indicate
proper operation.
B. Insert one end of the cable to the Ethernet port on the back panel of the DWL-2100AP and the other
end of the cable to your network (switch or router).
Note: You also have the option of connecting the DWL-2100AP directly to the computer
that will be used for configuration. The Link LED light will illuminate to indicate a proper
Ethernet connection. (Note: The Ethernet Port on the DWL-2100AP is Auto-MDI/MDIX.
Meaning you can use a straight-through or crossover Ethernet cable to connect to the Ethernet port on
the DWL-2100AP.)
C. The DWL-G650 Wireless Cardbus Adapter and the DWL-G520Wireless PCI Adapter will connect, out
of the box, with the DWL-2100AP, using their default wireless settings. Computers with 802.11b wireless
adapters can also connect to the DWL-2100AP.
Connect to Your Network
To Next Page
Loading...
Need help?
General
