DWR-956 Wireless AC1200 4G LTE Router
with Gigabit Ethernet Ports and 1 FXS Port
User Manual
Configuring via Web-based Interface
#
On the Wi-Fi / WPS page, you can enable the function for configuration of the WLAN and select a
method for connection to the WLAN.
The WPS function helps to configure the protected wireless network automatically. Devices
connecting to the wireless network via the WPS function must support the WPS function.
!
The WPS function allows adding devices only to the basic wireless network of the router.
!
Before using the function you need to configure one of the following authentication types:
Open with no encryption, WPA2-PSK or WPA-PSK/WPA2-PSK mixed with the
AES encryption method. When other security settings are specified, controls of the WPS
page on the tab of the relevant band are not available.
Figure 127. The page for configuring the WPS function.
You can activate the WPS function via the web-based interface or the hardware WPS button on the
cover of the device.
To activate the WPS function via the hardware button, move the Enable WPS function with
hardware button switch to the right on the tabs of both bands. Then, with the device turned on,
press the WPS button and release. The 2.4GHz and 5GHz LEDs should start blinking slowly. In
addition, upon pressing the button, the wireless interfaces of the device are enabled if they were
disabled before.
If you want to disable activating the WPS function via the hardware button, on the tabs of both
bands, move the Enable WPS function with hardware button switch to the left and make
sure that the WPS function is not activated via the web-based interface.
Page 156 of 302
To Next Page
Loading...
