DWR-956 Wireless AC1200 4G LTE Router
with Gigabit Ethernet Ports and 1 FXS Port
User Manual
Installation and Connection
Connecting to PC
1. Connect an Ethernet cable between any of LAN ports located on the back panel of the router
and the Ethernet port of your PC.
2. To connect via built-in LTE modem: insert a SIM card into the slot on the right side panel
of the router with the gold contacts facing towards the front of the device and gently push
until it clicks.
!
If you need to connect a SIM card or change it to another one when the router is powered
on, power off the router, insert or change the SIM card, and power on the router.
3. Connect the phone cable between the PHONE port of the router and the phone.
4. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
5. Turn on the router by pressing the ON/OFF button on its right side panel.
Then make sure that your PC is configured to obtain an IP address automatically (as DHCP client).
Page 21 of 302
To Next Page
Loading...
