DWR-956 Wireless AC1200 4G LTE Router
with Gigabit Ethernet Ports and 1 FXS Port
User Manual
Configuring via Web-based Interface
You can configure the following actions:
Parameter Description
Set Dial
Sets the number for abbreviated dial. In the Additional
parameter field, specify the actual number.
Enable Call Waiting
Enables the call waiting function.
Disable Call Waiting Disables the call waiting function.
Enable Do Not Disturb
Enables rejection of all incoming calls (the busy tone
will be heard).
Disable Do Not Disturb Disables rejection of incoming calls.
Enable Unconditional Forwarding
Enables forwarding for all calls.
Disable Unconditional Forwarding Disables forwarding for all calls.
Enable Call Forwarding On Busy
Enables call forwarding when this line is busy.
Disable Call Forwarding On Busy Disables call forwarding when this line is busy.
Enable Call Forwarding No
Answer
Enables call forwarding when this line gives no reply.
Disable Call Forwarding No
Answer
Disables call forwarding when this line gives no reply.
Enable Hot Line
Enables the hotline.
Disable Hot Line Disables the hotline.
Call by IP
Makes an outgoing call. In the Additional parameter
field, specify a part of the IP address for calling, for
example, 192.168.100. The remaining part of the IP
address is dialed on the connected phone. Use the
star (*) key to dial the dot (.) character.
Redial Enables number redial.
To use the call forwarding function on the connected phone, dial the corresponding prefix, wait to
hear the signal for number dialing in the receiver, and dial the number for forwarding on the phone.
You can also configure call forwarding in the List of SIP Lines section on the Profile Name /
Basic Settings page.
Page 241 of 302
To Next Page
Loading...
