D-Link DXS-1210-16TC - Page 131

DXS-1210 Series Smart Managed Switch CLI Reference Guide
128
Level: 12.
Usage Guideline
This command is used to add or delete VLAN IDs protected by the ERP mechanism.
Example
This example shows how toconfigure service protected VLAN as 100-200 for ERP instance 1.
Switch#configure terminal
Switch(config)# erps instance 1
Switch(config-erp-instance)#inclusion-list vlan-ids 100-200
Switch(config-erp-instance)#
18-6 instance
This command is used to create an ERP instance and enter ERP instance configuration mode.Use
the no form of this command to remove an ERP instance.
erps instance INSTANCE-ID
no erps instance INSTANCE-ID
Parameters
INSTANCE-ID
Specifies an ERP instance number. The valid values are from 1 to 32.
Default
None.
Command Mode
ERP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create or remove an ERP instance and enter ERP instance configuration
mode.
Example
This example shows how to create the ERP instance “1” in the physical ring named “ring2”.
Switch#configure terminal
Switch(config)# erps instance 1
Switch(config-erp-instance)#
18-7 level
This command is used to configure ring MEL value of an ERP instance.Use the no form of this
command to revert to the default setting.
level MEL-VALUE
no level