D-Link DXS-1210-16TC - Page 130

DXS-1210 Series Smart Managed Switch CLI Reference Guide
127
Parameters
VLAN-ID
Specifies the VLAN ID. The valid values are from 1 to 4094.
Default
None.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to assign the APS channel VLAN for an ERP instance. The APS channel
VLAN needs to be assigned before an ERP instance can be set to the operation state.
The specified APS channel VLAN does not need to exist to configure the command. But it needs to
exist before the instance can be set to the operation state.
If the APS channel VLAN is removed when the ERP instance is in operation, the ERP instance will
enter the operational disabled state.
Each ERP instances should have distinct APS channel VLAN.
Example
This example shows how toconfigure the APS channel VLAN “2” for the ERP instance “1”.
Switch(config)# erps instance 1
Switch(config-erp-instance)#r-aps channel-vlan 2
Switch(config-erp-instance)#
18-5 inclusion-list vlan-ids
This command is used to configure VLAN IDs protected by the ERP mechanism.Use the no form of
this command to delete the VLAN IDs.
inclusion-list vlan-ids VLAN-ID [, | -]
no inclusion-list vlan-ids VLAN-ID [, | -]
Parameters
VLAN-ID
Specified the VLAN IDs protected by the ERP mechanism. The range
is 1 to 4094.
,
(Optional) Specifies a series of VLANs, or separate a range of VLANs
from a previous range. No spacesare required before and after the
comma.
-
(Optional) Specifies a range of VLANs. No spacesare required before
and after the hyphen.
Default
None.
Command Mode
ERP Instance Configuration Mode.
Command Default Level