D-Link DXS-1210-16TC - Page 146

DXS-1210 Series Smart Managed Switch CLI Reference Guide
143
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the MAC address table’s aging time.
Example
This example shows how to display the MAC address table’s aging time.
Switch# show mac-address-table aging-time
Aging Time is 300 seconds.
Aging Destination Hit is disabled.
Switch#
19-9 show mac-address-table learning
This command is used to display the MAC-address learning state.
show mac-address-table learning [interface INTERFACE-ID [, | -]]
Parameters
INTERFACE-ID
(Optional) Specifies the interface to be display.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
-
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If the interface is not specified, all existing interfaces will be displayed.
Example
This example shows how to display the MACaddress learning status on all physical ports 1 to 10.