D-Link DXS-1210-16TC - Page 147

DXS-1210 Series Smart Managed Switch CLI Reference Guide
144
Switch# show mac-address-table learning interface ethernet 1/0/1-10
Port State
------------------------ --------
eth1/0/1 Enabled
eth1/0/2 Enabled
eth1/0/3 Enabled
eth1/0/4 Enabled
eth1/0/5 Enabled
eth1/0/6 Enabled
eth1/0/7 Enabled
eth1/0/8 Enabled
eth1/0/9 Enabled
eth1/0/10 Enabled
Switch#
19-10 show multicast filtering-mode
This command is used to display the filtering mode for handling multicast packets that are received on
an interface.
show multicast filtering-mode [interface VLAN-ID]
Parameters
interfaceVLAN-ID
(Optional) Specifies the VLAN to display.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Example
This example shows how to display the multicast filtering mode configuration for all VLANs.
Switch#show multicast filtering-mode
Interface Layer 2 Multicast Filtering Mode
-------------------------------- --------------------------------
default forward-unregistered
Total Entries: 1
Switch#