D-Link DXS-1210-16TC - Page 234

DXS-1210 Series Smart Managed Switch CLI Reference Guide
231
Command Default Level
Level: 12.
Usage Guideline
When entering the cost value, do not include a comma in the entry. For example, enter 1000, not
1,000.
Example
This example shows how to configure the interface’s path cost.
Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# spanning-tree mst 0 cost 17031970
Switch(config-if)#
29-6 spanning-tree mst configuration
This command is used to enter the MST Configuration Mode.Use the no form of this command to
revert to the default setting.
spanning-tree mst configuration
no spanning-tree mst configuration
Parameters
None.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enter the MST Configuration Mode.
Example
This example shows how to enter the MST Configuration Mode.
Switch# configure terminal
Switch(config)#spanning-tree mst configuration
Switch(config-mst)#
29-7 spanning-tree mst max-hops
This command is used to configure the MSTP maximum hop count value. Use the no form of this
command to revert to the default setting.
spanning-tree mst max-hops HOP-COUNT
no spanning-tree mst max-hops