D-Link DXS-1210-16TC - Page 235

DXS-1210 Series Smart Managed Switch CLI Reference Guide
232
Parameters
max-hops HOP-COUNT
Specifies the MSTP maximum hop count number. The range is from 1
to 40 hops.
Default
By default, this value is 20 hops.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the maximum hops for MSTP.
Example
This example shows how to configure the MSTP maximum hop count value.
Switch# configure terminal
Switch(config)#spanning-tree mst max-hops 19
Switch(config)#
29-8 spanning-tree mst hello-time
This command is used to configure the per-port hello time used in the MSTP version. Use the no form
of this command to revert to the default setting.
spanning-tree mst hello-time SECONDS
no spanning-tree mst hello-time
Parameters
SECONDS
Specifies to determine the time interval to send one BPDU at the
designated port. This value is either 1 or 2.
Default
By default, this value is 2.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This MSTP hello-time only takes effect in the MSTP mode.
Example
This example shows how to configure the port hello-time to 1 for the Ethernet interface eth1/01.