D-Link DXS-1210-16TC - Page 326

DXS-1210 Series Smart Managed Switch CLI Reference Guide
323
Display Parameters
Interface
The interface ID.
Action
The configured action, the possible actions are: Drop, Shutdown,
None.
Threshold
The configured threshold.
Current
The actual traffic rate which is currently flowing though the interface.
Its unit may be percentage, kbps, PPS based on the configured meter
mode. Because hardware can only counts by PPS, this value of this
filed may be a rough value for percentage and kbps.
State
The current state of storm control on a given interface for a given traffic
type. The possible states are:
Forwarding: No storm event has been detected.
Dropped: A storm event has occurred and the storm traffic exceeding
the threshold is dropped.
Error Disabled: The port is disabled due to a storm.
Link Down: The port is physically linked down.
Inactive: Indicates that storm control is not enabled for the given traffic
type.
40-5 show snmp-server traps storm-control
This command is used to Display storm control trap state.
show snmp-server traps storm-control
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to Display storm control trap state.
Example
This command is used to Display storm control trap state.
Switch# show snmp-server traps storm-control
storm occur : Disabled
storm clear : Disabled
Switch#