30D-Link GO-RT-N300 User Manual
Section 3 - Conguration
Access Control List
Click the ACL Setup button to edit the ACL (Access Control List). This takes you to the screen below.
Click to enable Wireless Access Control Mode. In this
mode, only listed wireless devices will be allowed to
connect to the wireless network.
Click the Apply button when you are done.
Enter the MAC Address of a device you wish to allow
access for to the WLAN.
Click the Add button when you are done. This will add
the device’s MAC Address to the table above.
Click the Delete button and the button in the Select field to delete the device.
Enable Wireless
Access Control
Mode:
MAC Address:
To Next Page
Loading...
