37
Configuration > Advanced > Network
Reset IP Address at next boot
Using the DCS-2000 with an Internet browser
(continued)
Once the DCS-2000 is configured, this box should be unchecked at all times. If
the box has been checked and the connection is lost, run Installation Wizard
to find the camera’s IP address.
IP address - Necessary for network identification.
Subnet mask - Used to determine if the destination is in the same
subnet. The default value is “255.255.255.0.”
SMTP
SMTP (mail) server 1 - The domain name or IP address of external mail
server.
SMTP account name 1 - The user name used to log into your e-mail
account (e.g. jdoe or jdoe@yourisp.com
depending on your ISP).
SMTP password 1 - The password used to log into your e-mail
account. (The password will appear as dots
instead of entered characters.)
Recipient email address 1 - The e-mail address of recipients for snapshots
or a system log file. Multiple recipients must be
separated by a semicolon “;”
Default router - The router used to forward frames to destinations
in a different subnet. Invalid router settings will
cause the failure of transmissions to different
subnets.
Primary DNS - Primary domain name server that translates names
to IP addresses.
Secondary DNS - Secondary domain name server to backup the
primary one.
General
SMTP(mail) server 2 -
The domain name or IP address of a secondary
mail server used only if the primary mail server
is unreachable.
To Next Page
Loading...
