Daedong KIOTI DK40SE - PRECAUTION FOR HANDLING 3-POINT HITCH IMPLEMENT

6 -2 DK35SE/DK40(C)SE/DK45(C)SE
HANDLING 3-POINT HITCH IMPLEMENT
PRECAUTION FOR HANDLING 3-POINT HITCH IMPLEMENT
1. When you remove and attach the
implement, make sure that no one
stands around the tractor or be-
tween the implements.
2. Remove and attach the implement
at a flat and safe place. Please use
proper lighting apparatus for night
work.
3. When you have mounted a heavy
implement, fix a balance weight in
front to keep the balance.
H11O524A
4. In case that you adjust the
implement, apply the parking brake
of the tractor, or stop the engine,
then perform the adjustment after
confirming that PTO switch and
PTO shift lever are in the “Neu-
tral” position.
5. When you do draft work, you must
use the draft hitch. Do not tow other
equipment than the draft hitch.
6. When you do draft work, or you are
working on the slope, you should
make the breadth of the tractor
wider (breadth of left and right tire).
7. Observe the surroundings while
turning as the total length of the trac-
tor is increased when an implement
is attached.
8. Do not load any person or objects
instead of the balance weight.
9. When working with a loader, attach
it to the rear of the tractor or use
the balance weight for 3-point hitch.
WARNING
!!
!!
!
Read and understand the
owner’s manual of the attached
implement thoroughly to oper-
ate it properly. If the instruc-
tions specified in the manual
are not followed, an accident
can occur.
When using a spray with haz-
ardous chemicals, be sure to
wear a protective mask and
keep precautions specified on
the chemical container.