Daedong KIOTI DK40SE - CHANGING ENGINE OIL AND REPLACING FILTER(L)

7 -13
MAINTENANCE
7
CHANGING ENGINE OIL AND
REPLACING FILTER(L)
H11O611A
H11O612A
1. Park the tractor on a level ground and
start the engine to warm it up.
2. Stop the engine, apply the parking
brake, and remove the drain plug.
3. To drain the used oil, remove the
drain plug at the bottom of the en-
gine and drain the oil completely into
the oil pan.
All the used oil can be drained out
easily when the engine is still warm.
(1) Oil Inlet (2) Gauge
(A) Oil level is acceptable within this range
(1) Drain Plug
(1) Engine Oil Filter
H11O613A
4. Remove the oil filter behind the cool-
ing fan on the right side of the engine.
5. Apply a thin film of oil to the O-ring
of a new filter and tighten the O-ring
firmly by hand.
6. Add the engine oil to the specified
level and tighten the oil filter to the
specified torque.
Oil capacity (with filter)
DK35(CH)SE
DK40(CH)SE
DK45(C)HSE
Model
1.5 U.S. gal.(5.8 )
2.1 U.S. gal.(8.0
)
2.1 U.S. gal.(8.0
)