Cylinder Head/Valve
Fix the tensioner shaft with a hard clip.
assemble a new gasket to the tensioner lifter, and
install the tensioner lifter on the cylinder.
Tighten the tensioner mounting bolts.
Torque values: 1.2kg-m (12N.m, 9ft-lb)
Remove the tensioner shaft clip from the
tensioner lifter. Assemble sealing washers and
screws to the tensioner lifter.
Torque values: 0.4kg-m(4N.m, 3ft-lb)
Fill clean engine oil into the operating parts of the
cylinder head.
Adjust the valve clearance. ( 3-5)
Remove oil from the cylinder head cover
grooves, and accurately assemble the gasket to
the cover.
Assemble the cylinder head cover.
Tighten the cylinder head cover bolt.
Torque values: 1.3kg-m (13N.m, 9ft-lb)
- Install the R/L shroud. ( 8-2)
- Install the luggage box. ( 4-5)
- Install the center cover. ( 4-4)
9-15
Cylinder head cover
Sealing screw
Cam chain
tensioner
Gasket
To Next Page
