Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 0 - October 31, 2013
Rev. 4
Page 8.9.2
● NOTE ●
For the R.H. rear seat, backrest tilting handle is located behind backrest.
●
c) Clear the carpet from under the seat to facilitate moving in rails.
d) Unlock seat using seat tilting handle (1) and tilt it forward.
e) Hold the seat in tilted position and unscrew quick links (7) of
strap (9) located under L.H. seatpan.
● NOTE ●
This operation is specific to L.H. seat.
●
f) Pull up and holdL.H.and R.H. rings(2), and turnknobs (8) by 90°
in order to release and keep locks (3) in up position.
g) Move theseat inthe railstolineuppads (4)with rail(5) apertures.
h) Remove the seat.
● NOTE ●
Ensure proper storage of strap (9) with L.H. rear seat to avoid loosing part.
●
D - Removal of intermediate seats - see figures 8.9.2 and 8.9.3
1) To remove intermediate seats, perform the following operations
a) Install protective covers.
b) Pull backrest bottom upholstery (25) to remove it.
c) Clear the carpet from under the seat to facilitate moving in rails.
d) Pull up locking handle (21) located under the pan, on the seat
rear side, to unlock it.
e) Move the seat in the rails to line up pads (23) with rail (24)
apertures.
f) Remove the seat.
g) Install backrest bottom upholstery (25).
▲ CAUTION ▲
In order to prevent deflectors damage, it is necessary to remove t
hem.
▲
2) Remove deflector (34) maintained with Velcro-type strap.
To Next Page
Loading...
