Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 0 - October 31, 2013
Rev. 4
Page 8.9.3
3) If necessary, remove the cabin central carpet.
● NOTE ●
If one of two cargo nets must be installed, it is necessary to use the carpet with
appropriate cuttings.
●
E - Removal of a cabinet
● NOTE ●
This operation must be carried out by a service center.
●
F - Cabin comfort - see figure 8.9.3
1) Blank off the hotair outlet, located forward thelarge door, withblanking
device assy (33) stored in storage bag - see figure 8.9.3 detail A.
2) Remove blanking plugs (32) located forward the large door and store
them into storage bag - see figure 8.9.3 detail B.
3) Remove blanking plugs (31) located in line with R.H. front side window
- see figure 8.9.3 detail C, and install them on holes located in line with
card table - see figure 8.9.3 detail D.
G - Installation of intermediate seats - see figures 8.9.2, 8.9.3 and 8.9.4
1) Installdeflector (34),ensuring that both redmarks (36) are aligned with
the deflector holes (35) - see figure 8.9.4.
● NOTE ●
Position deflectors (34) as indicated on label, according to future position of
intermediate seat.
●
2) Install intermediate seats.
● NOTE ●
If seats are installed facing flight direction (frontwards), the L.H. seat must be
installed on the right and the R.H. seat on the left in order to have the armrest
on aisle side.
●
a) Pull backrest bottom upholstery (25) to remove it.
b) Clear the carpet from seat area to facilitate moving in rails.
To Next Page
Loading...
