User’s Manual
14
Router IP Figure 3-5
Table 3-7 Parameter description of router IP
Set local IP address of the Router.
Set the subnet mask of the Router.
Set the internal gateway of the Router, the default internal gateway is the
address of the Router.
DNS server is automatically assigned by the operator's access server. If
there is a more stable and reliable DNS server, you can set it. Otherwise,
keep the default setting.
Click Save to save the configuration. Step 4
Click Apply Settings to apply the configuration. Step 5
(Optional) Click Cancel Changes to cancel the configuration. Step 6
WAN Port
You can set WAN port only when the WAN connection type is disabled.
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Setup > Basic Setup. Step 2
In WAN Port section, enable Assign WAN Port to Switch as needed. Step 3
WAN port Figure 3-6
Click Save to save the configuration. Step 4
Click Apply Settings to apply the configuration. Step 5
(Optional) Click Cancel Changes to cancel the configuration. Step 6
Network Address Server Settings（DHCP）
The Router can serve as a DHCP server. And DHCP server automatically assigns an IP
address for each computer in the network.
If the DHCP server function of the Router is enabled, you can set all the computers on the LAN
to automatically obtain an IP address and DNS.
To Next Page
Loading...