User’s Manual
15
Make sure that there is no other DHCP server in the network.
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Setup > Basic Setup. Step 2
In Network Address Server Settings (DHCP) section, set parameters. Step 3
DHCP setting Figure 3-7
Table 3-8 Description of DHCP parameters
DHCP Server and DHCP Forwarder. If DHCP Type is set to DHCP
Forwarder, you only need to set DHCP Server.
Enabled by default.
If there is already a DHCP server on network or you do not want
a DHCP server, select Disable.
If DHCP Type is set to DHCP Forwarder, you only need to set
the IP address of the DHCP Server.
Enter a numerical value for the DHCP server to start with when
assigning IP addresses.
The value range is 1–254.
The default value is 100.
Do not start with 192.168.1.1 (default IP address of the Router).
Enter the maximum number of PCs that the DHCP server can
assign IP addresses to.
The absolute maximum is 253 if 192.168.1.2 is your start IP
address.
To Next Page
Loading...