Step 2 Select the event type from the Event Type drop-down list, and then select the Enable
check box to enable the network detection function.
Step 3 Set alarm linkage actions. For details, see "5.1.1 Alarm Linkage".
Step 4 Click Save.
5.19.3 Setting Illegal Access
When you enter a wrong login password more than the set times, the system performs alarm
linkage.
Procedure
Step 1 Select Setting > Event > Abnormality > Illegal Access.
Figure 5-97 Illegal access
Step 2 Select the Enable check box to enable the illegal access detection function.
Step 3 Set Login Error.
If you consecutively enter a wrong password more than the set value, the account will be
locked.
Step 4 Set alarm linkage actions. For details, see "5.1.1 Alarm Linkage".
Step 5 Click Save.
5.19.4 Setting Voltage Detection
When the input voltage is higher than or lower than the rated value of the device, the system
performs alarm linkage.
Procedure
Step 1 Select Setting > Event > Abnormality > Voltage Detection.
Operation Manual
222
To Next Page
Loading...
Need help?
General
