1
1 Initialization
For first time login or after the VTO being reset, you need to initialize the web interface. The
default IP address of the VTO is 192.168.1.108, and make sure the PC is in the same network
segment as the VTO.
Connect the VTO to power source, and then boot it up. Step 1
Open the internet browser on the PC, then enter the default IP address of the VTO in Step 2
the address bar, and then press Enter.
Device initialization Figure 1-1
Enter and confirm the password, and then click Next. Step 3
The email setting interface is displayed.
Select the Email check box, and then enter your email address. This email address Step 4
can be used to reset the password.
Click Next. The initialization succeeded. Step 5
Click OK. Step 6
Login interface Figure 1-2
To Next Page
Loading...
Need help?
General
