Figure 4-98
Step 2 View parameters.
Destination IP: Please input valid IPV4 address and domain name.
Test: Click it to test the connection with the destination IP address. The test results can
display average delay and packet loss rate and you can also view the network status as OK,
bad, no connection and etc.
Network Sniffer backup: Please insert USB2.0 device and click the Refresh button, you can
view the device on the following column. You can use the dropdown list to select peripheral
device. Click Browse button to select the snap path. The steps here are same as preview
backup operation.
Network Sniff
You can view all connected network adapter names (including Ethernet, PPPoE, Wi-Fi, and 3G),
you can click the button on the right panel to begin Sniffer. Click the grey stop button to stop.
Please note system cannot Sniffer several network adapters at the same time.
After Sniffer began, you can exit to implement corresponding network operation such as login
WEB, monitor. Please go back to Sniffer interface to click stop Sniffer. System can save the
packets to the specified path. The file is named after “Network adapter name+time”. You can use
software such as Wireshark to open the packets on the PC for the professional engineer to solve
complicated problems.
4.18 Log Info
It is to search the logs of different types in different periods. View log information, clear or backup
log.
To Next Page
Loading...
