Zoom
Focus
Iris
Please click icon and to adjust zoom, focus and iris.
The corresponding item is grey if current unit does not support this function.
Figure 4-22
In X325H325H325H295H295H295H302HFigure 4-22, please click direction arrows (See Figure 4-23) to adjust PTZ position.
There are total 8 direction arrows. You can use the remote control to set.
Figure 4-23
4.5.3 3D Intelligent Positioning Key
In the middle of the eight direction arrows, there is a 3D intelligent positioning key. See X327H327H327H297H297H297H304HFigure
4-24. X Please make sure your protocol supports this function and you need to use mouse to
control.
Click this key, system goes back to the single screen mode. Drag the mouse in the screen to
adjust section size. The dragged zone supports 4X to 16X speeds. It can realize PTZ
automatically. The smaller zone you dragged, the higher the speed.
Figure 4-24
4.6 Preset/ Patrol/Pattern/Scan
In X328H328H328H298H298H298H305H X324H324H324H294H294H294H301HFigure 4-22X, please click the “set” button. The interface is shown as below. See X329H329H329H299H299H299H306HFigure 4-25.
Here you can set the following items:
Preset
To Next Page
Loading...
