Auto boot up: Set auto start time.
Auto shut down: Set auto shut down time.
ACC delay: The system auto latch time after ACC is off. The default setup is 0～65535minutes.
Forced shut down delay: Set force shut down delay time.
Step 3 Click Save button.
4.14.6 Import/Export
This function allows you to copy current system configuration to other devices. It also supports
import, create new folder, and delete folder and etc function.
Step 1 From Main menu->Setting->System->Import/Export, you can see the configuration file
backup interface is shown as below. See Figure 4-83.
Figure 4-83
Step 2 Set parameters.
Export: Please connect the peripheral device first and then go to the following interface.
Click Export button, you can see there is a corresponding “Config_Time” folder. Double click
the folder, you can view some backup files.
Import: Here you can import the configuration files from the peripheral device to current
device. You need to select a folder first. You can see a dialogue box asking you to select a
folder if you are selecting a file. System pops up a dialogue box if there is no configuration file
under current folder. After successfully import, system needs to reboot to activate new setup.
Format: Click Format button, system pops up a dialogue box for you to confirm current
operation. System begins format process after you click the OK button.
Note:
System cannot open config backup interface again if there is backup operation in the
process.
To Next Page
Loading...
