Figure 4-58
Step 2 Check the box to enable P2P function.
Step 3 Click Save to complete setup.
Step 4 The connection status becomes connected.
4.12.6 3G/4G
Make sure you have installed 3G/4G module.
Step 1 From main menu->Setting->Network->3G/4G, the setup interface is shown as below.
See Figure 4-59.
Please follow the steps listed below to set.
a) Boot up 3G module and then check the 3G Enable box to enable this function.
b) Please set AUTH, dial number, user name, and password. Please contact the VPN
administrator or your 3G service provider for detailed setup information.
c) 3G network is to connect to a platform so that you can view vehicle real-time information
such as real-time video, driver status, vehicle position and etc.
d) The Wi-Fi has the higher priority than the 3G network when these two signals are available
at the same. In this situation, the device uses Wi-Fi network by default and disconnect 3G
network.
e) If you find the 3G module cannot connect to the platform after dial. Please refer to the FAQ
or contact your local retailer for help.
Please refer to the following contents for the parameter information.
Pane 1: Display 3G signal intensity after you enabled 3G function.
Pane 2: Display 3G module configuration information after you enabled 3G function.
Pane 3: Display 3G module status information after you enabled 3G function.
It is to display current wireless network signal intensity such as EVDO, CDMA1x, WCDMA,
WCDMA, EDGE and etc.
3G network: It is to display current wireless network adapter name.
3G Enable/Disable: Check the box here to enable 3G module.
To Next Page
Loading...
