Dahua Mobile DVR Series - PTZ Control

36
Cable Connection
Please follow the procedures below to go on cable connection
 Connect the dome RS485 port to device RS485 port.
 Connect dome video output cable to device video input port.
 Connect power adapter to the dome.
Step 1 In the main menu, from Setting->System->PTZ or right click mouse and then select
PTZ.
PTZ interface is shown as in Figure 4-21.
Figure 4-21
Step 2 Set parameters.
 Channel: Select the current camera channel.
 Protocol: Select corresponding PTZ protocol(such as PELCOD)
 Address: Default address is 1.
 Baud rate: Select corresponding baud rate. Default value is 2400.
 Data bit: Select corresponding data bits such as 5/6/7/8. Default value is 8.
 Stop bit: Select corresponding stop bits such as 1/1.5/2. Default value is 1.
 Parity: There are three options: odd/even/none/mark/null. Default setup is none.
Step 3 Click Save button. Go back to the preview interface to control the camera.
4.5.2 PTZ Control
After completing all the setting please click save button. Right click mouse and then click PTZ.
Please note you can only go to the PTZ control interface when you are in 1-window display
mode.
Click Pan/Tilt/Zoom, the interface is shown as below. See X324H324H324H294H294H294H301HFigure 4-22.
Here you can set the following items:
 Step: value ranges from 1 to 8.